Skip to content
BeforeStreaky hard water stains around a piece of blue tape on the bat exhibit glass at Cameron Park Zoo in Waco, TX, before restoration
AfterThe bat exhibit glass at Cameron Park Zoo in Waco, TX, in the after photo, with the blue tape still on it
Bat exhibit

Can hard water stains be removed from zoo exhibit glass?

Yes. At Cameron Park Zoo in Waco, we removed hard water stains and heavy mineral deposits from the glass on two exhibits, the bat exhibit and the caiman exhibit in the Rainforest area. The glass was restored in place. No panels were replaced.

The Problem: Hard Water on Exhibit Glass

Exhibits like these get misted and cleaned with water all the time. Hard water leaves minerals behind every time it dries. Let it build up long enough and it turns into a crust and etches into the surface, and regular cleaning won't touch it.

That's a problem anywhere, but it's worse at an exhibit. The glass is the whole point. If visitors can't see through it, they can't see the animals.

The bat exhibit

The bat exhibit is a 30 foot long run of glass, six vertical panels, 10 feet tall. Water from misting or cleaning had left heavy, streaky hard water stains across the panels.

Streaky hard water stains on the bat exhibit glass at Cameron Park Zoo in Waco, TX, before restoration
Streaky hard water stains on the bat exhibit glass at Cameron Park Zoo in Waco, TX, before restoration

The caiman exhibit

The caiman exhibit in the zoo's Rainforest area has angled glass corner panels. The right panel had a thick white mineral crust on it, the heaviest of the whole job.

BeforeHeavy white mineral crust on the caiman exhibit glass at Cameron Park Zoo in Waco, TX, before restoration
AfterThe right corner panel of the caiman exhibit glass at Cameron Park Zoo in Waco, TX, clear after mineral deposit removal
Caiman exhibit

Restoration vs. Replacement for Exhibit Glass

Replacing exhibit glass this size means ordering custom glass, taking the old panels out, and shutting the exhibit down while that happens. Restoring the glass takes care of the stains with the glass left in the frame.

Our Process

  1. On-site inspection. Before we started on the bat exhibit, we inspected the glass on site to set the final scope. The quote covered resurfacing plus hard water stain removal.
  2. Setting the scope. On the bat exhibit, we focused on the lower 7 to 8.5 feet of each panel. That's the part visitors actually look through.
  3. Stain and mineral removal. We removed the hard water stains and mineral deposits with the glass in place, then polished it back to clarity.
  4. Final check. We checked the panels from normal viewing positions. As the quote noted, minor optical variance at oblique angles is normal on resurfaced glass.

The Result

The caiman exhibit glass at Cameron Park Zoo in Waco, TX, with both corner panels clear after mineral deposit removal
The caiman exhibit glass at Cameron Park Zoo in Waco, TX, with both corner panels clear after mineral deposit removal

In Doug's words:

"Hands down the gnarliest mineral deposits I've ever or hope to ever encounter again, but all in all it came out pretty darn good!"

Doug MacDonald, Glass Savers

Project Details

Detail Bat exhibit Caiman exhibit
Client Cameron Park Zoo Cameron Park Zoo
Location Waco, TX (about 1.5 to 2 hours from Austin) Waco, TX, Rainforest area
Glass 6 vertical panels, 30 ft run, 10 ft tall Angled glass corner panels
Damage Heavy streaky hard water stains from misting or cleaning Heavy white mineral crust
Work Resurfacing plus hard water stain removal on the lower 7 to 8.5 ft Mineral deposit removal
Status Finished Finished

Why Resurface Instead of Replace?

  • Cost: Save 50-80% versus replacing the window or door.
  • Less disruption: The glass stays in the frame. No removal and no waiting on custom glass.
  • No waste: The original glass stays in use instead of going to a landfill.

Have Hard Water Stains on Exhibit or Commercial Glass?

Zoos, storefronts, offices and homes all get hard water damage, usually from sprinklers, misters or cleaning water left to dry on the glass. We've been doing this since 2009, and we work in Austin and travel for larger jobs.

Make sure whoever you are considering to restore your glass has plenty of before and after photos, references from happy customers, and proper liability insurance. They should also be willing to do a demo on a portion of your glass before you commit to a large project. We welcome a side-by-side demo with any company.

Text us photos of the glass, or call (512) 626-1270.

FAQ

Can hard water stains be removed without replacing the glass?

Yes. Most hard water stains can be removed by resurfacing and polishing the glass in place. At Cameron Park Zoo, we restored the lower 7 to 8.5 feet of six bat exhibit panels and the caiman exhibit glass without replacing any of them.

What causes hard water stains on exhibit glass?

Water that dries on the glass, from misting systems, sprinklers or cleaning, leaves minerals behind. Over time those minerals build up into a crust and etch into the surface, and regular glass cleaner won't remove them.

Can heavy mineral crust on glass be removed?

Often, yes. The caiman exhibit at Cameron Park Zoo had the heaviest mineral deposits Doug MacDonald says he has ever worked on, and in his words it still came out pretty darn good. The best way to know for your glass is a demo on a small area first.

Do you work outside Austin?

Yes. Waco is about 1.5 to 2 hours from Austin. Jobs more than a 60-minute drive from Steiner Ranch, up to 3 hours, have a $750 minimum. For jobs more than 3 hours away, pricing starts at $10k.

Will the restored glass look perfect from every angle?

We aim for results as close to perfect as humanly possible. Minor optical variance at oblique angles is normal on resurfaced glass, and we put that in writing on the quote.